Longfield Studless Hub (Toyota)

Rating:
% of 100
$952.43
17 In Stock
SKU
302583-1-KIT

Longfield Studless Hubs

A new, innovative, never before seen product, our Longfield™ Studless Hubs set the bar in quality and performance. The Longfield™ Studless Hub replaces the weaker, prone-to-breaking locking hubs, hub gears, and hub studs by utilizing a stud-less hub design and inner locking puck. Chances are, if you were to break the studs in your hub, the threads would be damaged and the hub would need to be replaced. With the Longfield™ Studless Hubs, you will never again need to worry about your hubs, hub gears, and hub studs breaking on the trail.

The Longfield™ Studless Hub and Inner Locking Puck are both constructed out of chromoly steel for superior strength and quality. The Longfield™ Studless Hubs are stronger than the OEM locking hubs and are designed to handle even higher torque loads than our Creeper Drive Flanges. The Longfield™ Studless Hubs will also include a full set of front wheel bearings to replace your old, worn out bearings.

We are so confident with the quality and strength of our new, innovative Longfield™ Studless Hubs, we are offering it with our legendary, no-questions asked lifetime warranty.

Note: On 1979-1981 Toyota Pickups, you will need the following additional parts:

  • IFS Vented Rotors (part #140332-1-KIT)
  • IFS Calipers (part #140444-1-KIT & 140445-1-KIT)
  • IFS Caliper Brake Pads (part #140091-1-KIT)
  • Front Wheel Studs (part #140392-1-KIT)

Note: These will lock your front axle into 4WD. To unlock your front axle, you will need to remove the locking puck.

⚠ WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov

  • Stud-less hub design and inner locking puck
  • Studless Hub and Inner Locking Puck are both constructed out of chromoly steel
  • Stronger than the OEM locking hubs and are designed to handle even higher torque loads than our Creeper Drive Flanges

Note: If you are replacing 1979-1981 Toyota Pickup hub bodies, you will need the following additional parts:

  • FJ60 Vented Rotors (part #140332-1-KIT)
  • Brake Calipers (part #140444-1-KIT & 140445-1-KIT)
  • Brake Pads (part #140091-1-KIT)
  • Front Wheel Studs (part #140392-1-KIT) (if needed)

Note: These will lock your front axle into 4WD.

  • 1979-1985 Toyota Pickup, 4WD with Solid Axle
  • 1985 Toyota 4Runner, 4WD with Solid Axle
  • Rock Assault Front Axle Housing

Note: On 1979-1981 Toyota Pickups, you will need the following additional parts:

  • IFS Vented Rotors (part #140332-1-KIT)
  • IFS Calipers (part #140444-1-KIT & 140445-1-KIT)
  • IFS Caliper Brake Pads (part #140091-1-KIT)
  • Front Wheel Studs (part #140392-1-KIT)

All products carry our 12 Month Limited Warranty. All warranties are limited to the original purchaser and are not transferable to subsequent owners of the product. The warranty period begins on the purchase date. Trail-Gear warrants that it will repair or replace, free of charge, any eligible product which, under normal conditions of use and service, proves to be defective in materials or workmanship. This warranty does not cover any labor costs incurred in diagnosis of defects, removal or reinstallation of a product, nor does it cover any other consequential expenses.

Please read and review our return and warranty requirement document before sending in products.

Warranty Exclusions


Trail-Gear Inc. warranty does not cover, and Trail-Gear Inc. shall not be liable for, any undertaking, representation, or agreements made by dealers or other third parties selling Trail-Gear products, except where such agreements are within the provisions of this Warranty.

Specifically excluded from this warranty are failures caused by lack of maintenance, misuse, negligence, modification, abuse, improper application, crash damage, installation or operation, or failures caused by unauthorized service or use of unauthorized parts.

Additionally excluded from this warranty are parts which are subject to normal wear and tear, such as bushings, fluids, hoses, gaskets, belts, etc. Products not manufactured by Trail-Gear Inc. are excluded from any warranty and shall be handled with the original manufacturer.

All parts used in a competitive racing environment are excluded from this warranty. If, after inspection, a part returned, under any warranty, is deemed to be ineligible for warranty repair or replacement, the part may be repaired or replaced for a discounted cost. Return shipping charges will apply. Any part for which a warranty replacement is sought must be returned to Trail-Gear Inc. before any replacement items can be shipped. All replacement parts shipped before the suspect part has been received and evaluated by Trail-Gear, MUST BE PAID IN FULL. In such a case, after the suspect part has been received and approved for a warranty replacement, the purchase price for the replacement will be refunded.

    To begin your warranty claim:
  • Please contact Trail-Gear Inc. at 559-252-4950 or email sales@trail-gear.com prior to returning any product under warranty to verify that warranty is still in effect.
  • Products must be shipped back to Trail-Gear Inc. at the expense of the customer.
    Ship all products to:
    ATTN: WARRANTY
    5356 E. Pine Avenue
    Fresno, CA 93727.
  • Please place a clearly marked copy of the original invoice inside the package.
  • Please include a short note stating the problem you are experiencing.

If any of the above mentioned policy is not met, the package will be refused or warranty claim denied. By completing the steps above, this will ensure faster processing of your claim so that Trail-Gear can get your product back to you as quickly as possible. All warranties are generally processed within 2-3 business days of Trail-Gear receiving the parts from you. Additional delays may be incurred if product needs additional testing or repairing.

If you are an international customer, please email the warranty department at sales@trail-gear.com to receive further instruction. International customers may have the option to field destroy an approved warranty to avoid costly return shipping. In this case, any shipping charges for replacement parts will be at the expense of the customer.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
Copyright © 2023 Trail-Gear, Inc. All rights reserved.