Li-Po Battery
Packs
|
|
This Li-Po battery
is the perfect size to sit on your front axle
between your steering knuckle and steering
servo. This will get your CG down low
where you need it for rock crawling. This
battery gives you the power you need when you
need it for wheel speed.
To relocate the
battery to the front axle you will need part
#210017 (Battery Relocation Plate), found
here.
Note:
11.1v Li-Po is used with Teken and Mamba Max
speed controls. 7.4v Li-Po to be used with
Novak speed controls.
|
 |
1500mAh, 11.1v,
Li-Polymer Battery Pack, $34, 210105 |
|
|
1350mAh, 7.4v,
Li-Polymer Battery Pack, $31, 210106 |
|
210105
- Continuous Discharge
Rate: 20C / 30A
- Burst Discharge Rate:
20C / 37.5A
- Discharge (Output)
Leads: 16 AWG silicon wire, 95mm long
- Dimensions: 72 x 35 x
25mm
- Weight: 120g
- Connector: Dean's End
(Female)
210106
- Continuous Discharge
Rate: 20C / 27A
- Burst Discharge Rate:
30C / 33.8A
- Discharge (Output)
Leads: 16 AWG silicon wire, 95mm long
- Dimensions: 72 x 35 x
15mm
- Weight: 80g
- Connector: Dean's End
(Female)
|
|
Multiplex
LN-5014 Battery
Charger
|
|
The multi-talented charger, for LiPo, LiIo, NiCd,
NiMH and lead acid batteries. The multi charger
LN-5014 is a high-performance charger suitable
for use with all types of batteries used in
modeling. A generously sized backlit LCD screen
helps with setting up of charge /
discharge parameters, and keeps the user
informed at all times during the charge process.
Input 11-15VDC
- Light, compact, easy to transport
- Strong
aluminum case
- Ultra-simple four-button operation
- Clearly laid-out backlit LCD screen: two
lines, 16 characters each
- Constant current / constant voltage
charging for LiPo and LiIo batteries
- Delta-Peak cut-off for NiCd and NiMH
batteries
- Charge and discharge program
- Cyclic charge / discharge (max. five
cycles, finishing charged or discharged
- Ideal for all model aircraft, car and boat
operators
- 4 mm
gold-contact input sockets for direct
connection
- Crocodile clips
with 4 mm sockets included
|
|
|
Multiplex Battery
Charger,
$74.99, 210068 |
|
|
|
Castle
Battery Eliminator Circuit
|
The Castle battery
eliminator circuit is a little device that
eliminates the need for a receiver and servo
battery pack. It draws higher voltage from the
motor batteries and drops it to a voltage level
that is suitable for your receiver and servos.
-
Peek Current
Output 10 Amps
-
Output 5.1 volts
out of the package, user may set output
voltage from 4.8 to 9 using the Castle Link
(sold separately).
-
Input Voltage:
5v to 25.2v (2S to 6S LiPo)
-
Length: 1.2”
(30mm)
-
Width: 0.6”
(15mm)
-
Height: 0.4”
(10mm)
-
Weight: 0.4 oz
(11 grams)
|
|
|
Castle Battery Eliminator Circuit,
$19.95, 210086 |
|
 |
| |
|
|
