| |
 |
|
|
|
Creeper JointTM Drive
Shaft U-Joints
Trail-Gear now offers the strongest U-Joint on the
market. We took the stock U-joint and kicked it up a
notch by adding additional material to center of the
joint. The Creeper JointTM
has been tested to 4,700 ft-lbs of torque in our axle
testing machine. These U-joints fit most 1979-1995 4wd
applications. Includes four install clips and Zerk grease fitting (not shown in photo).
 |
U-joint, Creeper
Joint, $40, 100065-1 |
|
 |
|
|
Stock Replacement
Drive Shaft U-Joints
OEM
Replacement U-Joint. We have tested these joints to 3700
ft-lbs of torque before failure. These U-Joint fit most
1979-1995 4wd applications. Includes four install clips
and Zerk grease fitting (not shown in photo).
|
|
U-joint, Toyota
OEM, $20, 100048-1 |
|
 |
|
10" Long Spline
Drive Shaft Kit
Super
flexible suspension systems require more slip spline
then the stock drive shaft is able to provide. The
result with a stock slip spline is the drive shaft pulls
apart on the trail. This long spline kit is
designed to replace the stock slip section and nearly
doubles the useable slip length. To install this kit the
stock slip section and tubing is cut off and replaced
with our long spline section and new tubing.
Our
drive shaft kits are also stronger then stock. Our
testing shows that a stock drive shaft will twist off
and fail at after a maximum load of 3,900 ft/lbs of
torque is applied. Our shaft kits test to a maximum of
4800 ft/lbs or torque. This is accomplished in two ways;
first we increase the size of the material both on the
inside and outside of the slider section. Then we
specially heat-treat the material to increase its
strength.
Each kit comes with a Heavy Duty U-joint
installed. Full circle retaining rings are installed to
securely hold the u-joint in place.
This product is a
heavy duty replacement part and is not recommended for
applications requiring a balanced driveshaft. Not
recommended for use on the street or speeds over 50mph.
**This
driveline can not be balanced.
|
|
Driveline Kit,
Long Travel, w/Matsuba Joint, $179, 100005-1-K |
|
|
Driveline Kit,
Long Travel, w/Creeper Joint, $199, 100007-1-K |
|
 |
|
This is a
sample of how the finished product will look. |
|
|
Drive Shaft
Bolts Replacement drive shaft bolts, nuts and washers. Bolts
include factory thread lock adhesive applied to threads.
|
|
Drive Shaft Bolt,
$1.86, 140059-1 |
|
|
Drive Shaft Bolt,
Lock Washer, $0.54,
100054-1 |
|
|
Drive Shaft Bolt,
Flange Nut, $2.63, 140058-1 |
|
 |
|
|
|
